Home › Vehicle Interior › SEAT › POWER SEAT SWITCH › from 2020.08
RM32K0E _58 Vehicle Interior _061825 SEAT _0409032 POWER SEAT SWITCH A

SEAT  POWER SEAT SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front power seat switch removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Panoramic view monitor system (Click here)

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·
B407261

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: When performing learning using the GTS

Click here(Click here)

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Simple intelligent parking assist system*1
Parking support brake system*1

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Power seat is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 71868A 3.REMOVE NO. 1 FRONT SEAT INNER CUSHION SHIELD

Hide 71812D 4.REMOVE FRONT SEAT CUSHION SHIELD

Hide 84921D 5.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

Hide 84921K 6.REMOVE RECLINING POWER SEAT SWITCH KNOB

Hide 72714 7.REMOVE SEAT ADJUSTER SHIELD CLAMP BRACKET

Hide 84922C 8.REMOVE FRONT POWER SEAT SWITCH

a.
B439702

Remove the 2 screws and front power seat switch from the front seat cushion shield.