The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion heater assembly removal/installation are shown below.
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Wear protective gloves. Sharp areas on the parts may injure your hands.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Power seat is available only on the driver side.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY
71074S
2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER
71868A
3.REMOVE NO. 1 FRONT SEAT INNER CUSHION SHIELD
71812D
4.REMOVE FRONT SEAT CUSHION SHIELD
71862
5.REMOVE FRONT SEAT INNER CUSHION SHIELD
6.REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY
7.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
71072S
8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER
87510L
9.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY
Remove the 14 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.