Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM (w/ Headlight ECU) › from 2020.08
RM32K0E _59 Vehicle Exterior _061162 LIGHTING (EXT) _0408676 LIGHTING SYSTEM(w/ Headlight ECU) D

LIGHTING (EXT)  LIGHTING SYSTEM(w/ Headlight ECU)  OPERATION CHECK  


AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK


NOTICE:

Make sure that the customize settings are set to default when performing the automatic light control system operation check.

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM (w/ Headlight ECU)>CUSTOMIZE PARAMETERS


a.

Turn the power switch to on (IG).


b.

Turn the light control switch to the AUTO position.


c.

Cover the automatic light control sensor.


d.

Check that the taillights and low beam headlights come on.


e.

Uncover the automatic light control sensor.


f.

Check that the low beam headlights and taillights go off.



LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (except Driver Door-linked Auto Light Turn-off System)


a.

When the light control switch is in the tail or head position

i.

Turn the power switch to on (IG).


ii.

Turn the headlights or front fog lights on.


iii.

Turn the power switch off.


iv.

Check that the headlights and front fog lights go off immediately.

HINT:

The taillights and rear fog light remain on.




b.

When the light control switch is in the AUTO position

i.

Turn the power switch to on (IG).


ii.

Turn the taillights, headlights, front fog lights or rear fog light on.


iii.

Turn the power switch off.


iv.

Check that all of the lights go off immediately.




LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (for Driver Door-linked Auto Light Turn-off System)


a.

Close all of the doors.


b.

Turn the power switch to on (IG).


c.

Turn the headlights, front fog lights, taillights, clearance lights and license plate lights on.


d.

Turn the power switch off.


e.

Open the driver door.


f.

Check that all of the lights go off immediately.



LIGHT AUTO TURN-OFF SYSTEM OPERATION CHECK (w/ Delay Function)


a.

When the taillights are on (low beam headlights are not on)

i.

Close all of the doors.


ii.

Turn the power switch to on (IG).


iii.

Turn the taillights on.


iv.

Turn the power switch off.


v.

Open the driver door.


vi.

Check that all of the lights go off immediately.



b.

When the low beam headlights are on

i.

Close all of the doors.


ii.

Turn the power switch to on (IG).


iii.

Turn the low beam headlights on.


iv.

Turn the power switch off.


v.

Open any of the doors.


vi.

Close the door.


vii.

Check that all of the lights go off after 30 seconds (delay function).

HINT:

Before the lights go off, if the lock button on the key is pushed after all of the doors are locked, all of the lights will go off immediately.





DAYTIME RUNNING LIGHT SYSTEM OPERATION CHECK


a.

Turn the light control switch to the off* or AUTO position (with the taillights not turned on via the automatic light control system).

*: w/ Light Control Switch Off Position



b.

Start the engine.


c.

Release the parking brake.


d.

Check that the daytime running lights come on.



EXTENDED HEADLIGHT LIGHTING SYSTEM OPERATION CHECK (w/ Extended Headlight Lighting System)


a.

Turn the power switch off.


b.

Turn the light control switch to the AUTO position.


c.

Pull the light control switch to flash the headlights once.


d.

Check that the low beam headlights come on for approximately 30 seconds.



DOOR MIRROR FOOT LIGHT CONTROL OPERATION CHECK (w/ Door Mirror Foot Light Control)


a.

The operation and condition of this control are described below.

Operation Condition
Fade in and illuminate constantly When any of the following conditions is met, the lights fade in and illuminate constantly:
·

A key is detected in the actuation area.*1

·

Any door is unlocked when the power switch is off and all of the doors are closed.


Illuminate for 15 seconds, and then fade out When any of the following conditions is met, the lights illuminate for 15 seconds, and then fade out:
·

An actuation area-linked function is used.*1, *2

·

Any door is unlocked when the power switch is off and all of the doors are closed.


Fade out immediately When the following condition is met, the lights fade out immediately:
·

The power switch is turned from off to on (IG).

·

A key is not detected in the actuation area.*1

·

All doors are locked when all doors are closed and any door is unlocked.



*1: w/ Entry and Start System


HINT:

*2: When the lights are on, if the key leaves the actuation areas around the doors, the lights fade out after approximately 3 seconds.




AFS OPERATION CHECK


a.

Perform the following operation with the low beam headlights on and check that the headlight ECU sub-assembly LH performs low speed control of the AFS:

·

Drive the vehicle at a speed between 10 km/h (6 mph) and 30 km/h (19 mph) and turn the steering wheel 6 degrees or more.



b.

Perform the following operation with the low beam headlights on and check that the headlight ECU sub-assembly LH performs medium-to-high speed control of the AFS:

·

Drive the vehicle at a speed of 30 km/h (19 mph) or more and turn the steering wheel 7.5 degrees or more.



c.

Perform any of the following operations and check that the headlight ECU sub-assembly LH cancels control of the AFS:

·

The engine switch not on.

·

Turn the low beam headlights off.

·

Decrease the vehicle speed to less than 5 km/h (3 mph).

·

Reduce the steering angle to less than 6 degrees.

·

Move the shift lever to N or R.