The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the front bumper assembly removal/installation are shown below.
53141F
1.REMOVE RADIATOR COVER
for 2ZR-FXE:
Remove the 5 clips and 2 hood bumper cushions.
for M20A-FXS:
Remove the 4 clips and 2 hood bumper cushions.
|
Remove in this Direction |
Disengage the claws and guides to remove the radiator cover as shown in the illustration.
75602A
2.SEPARATE FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
Protective Tape |
Apply protective tape around the front fender moulding sub-assembly LH.
Remove the 3 screws.
Remove the 2 clips.
| *a | 90 deg |
Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
|
Place Hand Here |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Pull back the edge of the front fender liner LH and disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.
Do not apply excessive force when pulling back the front fender liner LH.
To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly LH.
Disengage the clips and disconnect the front fender moulding sub-assembly LH.
75601A
3.SEPARATE FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
4.REMOVE FRONT BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape around the front bumper assembly.
Use the same procedure for the RH side and LH side.
Remove the 3 bolts.
Remove the 6 screws.
|
Place Hand Here |
|
Remove in this Direction |
Disengage the claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
w/ Headlight Cleaner System:
Disconnect the washer hose and drain the washer fluid.
Use a container to collect the washer fluid.
w/ Wire Harness:
Disconnect the connector A.
w/ Toyota Safety Sense:
Disconnect the connector B.
|
Place Hand Here |
|
Remove in this Direction |
Disengage the claws to remove the front bumper assembly as shown in the illustration.