53141F
1.REMOVE RADIATOR COVER
Remove the 5 clips and 2 hood bumper cushions.
|
Remove in this Direction |
Disengage the claws and guides to remove the radiator cover as shown in the illustration.
75602A
2.SEPARATE FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
Protective Tape |
Apply protective tape around the front fender moulding sub-assembly LH.
Remove the 3 screws.
Remove the 2 clips.
| *a | 90 deg |
Using a screwdriver, turn the pin 90 degrees to remove the pin hold clip.
|
Place Hand Here |
|
Push |
|
Remove in this Direction |
Pull back the edge of the front fender liner LH to disengage the claws by pushing the area indicated by the arrow in the illustration with a finger.
Do not apply excessive force when pulling back the front fender liner LH.
To avoid damaging the claws, do not forcibly pull the front fender moulding sub-assembly LH.
Disengage the clips to disconnect the front fender moulding sub-assembly LH.
75601A
3.SEPARATE FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
4.REMOVE FRONT BUMPER ASSEMBLY
|
Protective Tape |
Apply protective tape around the front bumper assembly.
Use the same procedure for the RH side and LH side.
Remove the 6 screws.
|
Place Hand Here |
|
Remove in this Direction |
Disengage the claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Disconnect the 2 connectors.
Remove the 3 bolts.
|
Place Hand Here |
|
Remove in this Direction |
Disengage the claws to remove the front bumper assembly as shown in the illustration.