1.INSTALL FRONT BUMPER ASSEMBLY
Move the front bumper assembly into position.
Connect the 2 connectors.
|
Install in this Direction |
Temporarily install the front bumper assembly by engaging the claws as shown in the illustration.
Install the 3 bolts.
|
Install in this Direction |
Engage the claws as shown in the illustration.
Use the same procedure for the RH side and LH side.
Install the 6 screws.
|
Install in this Direction |
Install the pin hold clip as shown in the illustration.
Insert the pin hold clip with the slot aligned vertically.
Do not rotate the clip after inserting it.
After installation, confirm that the slot is aligned vertically.
Use the same procedure for the RH side and LH side.
Remove the protective tape.
75602A
2.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH
|
Install in this Direction |
Engage the clips and claws to install the front fender moulding sub-assembly LH as shown in the illustration.
Install the 3 screws.
Install the 2 clips.
Remove the protective tape.
75601A
3.INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
53141F
4.INSTALL RADIATOR COVER
|
Install in this Direction |
Engage the guides and claws to install the radiator cover as shown in the illustration.
Install the 5 clips and 2 hood bumper cushions.
5.ADJUST FOG LIGHT ASSEMBLY