This DTC is stored when the radio and display receiver assembly detects an open in the front speaker LH circuit by energizing the speaker line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1ACB71 | Front Left Speaker Cable Actuator Stuck | Open in the front speaker LH circuit is detected.
(1 trip detection logic) |
·
Harness or connector ·
Front No. 1 speaker assembly LH ·
Front No. 2 speaker assembly LH ·
Front No. 3 speaker assembly LH*2 ·
Radio and display receiver assembly*1 ·
Stereo component amplifier assembly*2 |
*1: for 6 Speakers
*2: for 9 Speakers
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 6 Speakers | A |
| for 9 Speakers | B |
A
B
Disconnect the F132 radio and display receiver assembly connector.
Disconnect the J13 front No. 1 speaker assembly LH connector.
Disconnect the F86 front No. 2 speaker assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F132-2 (FL+) - F86-4 (TWL+) | Always | Below 1 Ω |
| F132-7 (FL-) - F86-2 (TWL-) | Always | Below 1 Ω |
| J13-2 - F86-3 (+) | Always | Below 1 Ω |
| J13-1 - F86-1 (-) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
In accordance with the display of the GTS, perform a speaker circuit energization inspection.
| Tester Display |
|---|
| Speaker Line Electricity Check |
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1ACB71 is output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the J13 front No. 1 speaker assembly LH connector.
Disconnect the F53 front No. 2 speaker assembly LH connector.
Disconnect the F90 front No. 3 speaker assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-11 (FL+) - F90-2 (TWL+) | Always | Below 1 Ω |
| F75-26 (FL-) - F90-4 (TWL-) | Always | Below 1 Ω |
| J13-2 - F90-1 (+) | Always | Below 1 Ω |
| J13-1 - F90-3 (-) | Always | Below 1 Ω |
| F75-9 (TWL+) - F53-2 | Always | Below 1 Ω |
| F75-24 (TWL-) - F53-1 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
In accordance with the display of the GTS, perform a speaker circuit energization inspection.
| Tester Display |
|---|
| Speaker Line Electricity Check |
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1ACB71 is output | B |
A
B