Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type with Single Knob Type) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0522654 NAVIGATION SYSTEM(for Radio and Display Type with Single Knob Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type with Single Knob Type)  Sound cannot be Heard Sound Quality is Poor only when Replaying USB Storage Device or "iPod"  


WIRING DIAGRAM

E446459E15
0.979,0.604 1.594,0.802 0.615,0.198 10 false UPI 0.875,1.188 1.49,1.385 0.615,0.198 10 false UDO- 0.854,1.802 1.469,2 0.615,0.198 10 false UDO+ 0.865,2.458 1.479,2.656 0.615,0.198 10 false UJSG 0.865,3.052 1.479,3.25 0.615,0.198 10 false UJSS 5.938,0.615 6.552,0.813 0.615,0.198 10 false USV1 5.948,1.198 6.563,1.396 0.615,0.198 10 false US1- 5.948,1.792 6.563,1.99 0.615,0.198 10 false US1+ 5.948,2.438 6.563,2.635 0.615,0.198 10 false UGD1 5.938,3.052 6.552,3.25 0.615,0.198 10 false USG1 1.875,4.188 4.479,4.427 2.604,0.24 10 false : Data Signal (USB Communication Line) 0.479,3.438 1.083,3.667 0.604,0.229 10 false j13 0.448,3.615 3.365,3.865 2.917,0.25 10 false No. 1 Stereo Jack Adapter Assembly 4.906,4.198 5.802,4.427 0.896,0.229 10 false *: Shielded 5.792,3.594 6.99,4.198 1.198,0.604 10 false Radio and Display Receiver Assembly 5.802,3.427 6.417,3.625 0.615,0.198 10 false j14 1.313,0.5 1.531,0.698 0.219,0.198 10 false 1 5.771,0.5 5.99,0.698 0.219,0.198 10 false 1 1.323,1.063 1.542,1.26 0.219,0.198 10 false 2 1.313,1.677 1.531,1.875 0.219,0.198 10 false 3 1.313,2.333 1.531,2.531 0.219,0.198 10 false 4 1.313,2.938 1.531,3.135 0.219,0.198 10 false 5 5.771,1.063 5.99,1.26 0.219,0.198 10 false 2 5.771,1.667 5.99,1.865 0.219,0.198 10 false 3 5.771,2.344 5.99,2.542 0.219,0.198 10 false 4 5.76,2.948 5.979,3.146 0.219,0.198 10 false 5 3.563,2.823 3.833,3 0.271,0.177 10 false *

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Radio and Display Type with Single Knob Type)>PRECAUTION


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the j14 radio and display receiver assembly connector.


b.

Disconnect the j13 No. 1 stereo jack adapter assembly connector.


c.
E433937C07
1.458,0.167 1.958,0.417 0.5,0.25 1.458,1.833 1.958,2.083 0.5,0.25 1.333,1.25 1.604,0.938 true 2.083,1.25 1.792,0.938 true 1.917,1.5 1.708,1.094 true 1.333,2.917 1.625,2.604 true 2.083,2.917 1.813,2.604 true 1.917,3.167 1.719,2.76 true 0.667,0.167 0.917,0.333 0.25,0.167 10 false *a 0.667,1.833 0.917,2 0.25,0.167 10 false *b 1.594,0.208 1.906,0.365 0.313,0.156 10 false j14 1.583,1.875 1.896,2.031 0.313,0.156 10 false j13 0.938,1.167 1.417,1.333 0.479,0.167 10 false US1+ 2.104,1.167 2.583,1.333 0.479,0.167 10 false US1- 1.958,1.417 2.438,1.583 0.479,0.167 10 false USG1 0.927,2.823 1.406,2.99 0.479,0.167 10 false UDO+ 2.125,2.833 2.604,3 0.479,0.167 10 false UDO- 1.958,3.083 2.438,3.25 0.479,0.167 10 false UJSS
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
j14-2 (US1-) - j13-2 (UDO-) Always Below 1 Ω
j14-3 (US1+) - j13-3 (UDO+) Always Below 1 Ω
j14-5 (USG1) - j13-5 (UJSS) Always Below 1 Ω
j14-2 (US1-) or j13-2 (UDO-) - Body ground Always 10 kΩ or higher
j14-3 (US1+) or j13-3 (UDO+) - Body ground Always 10 kΩ or higher
j14-5 (USG1) or j13-5 (UJSS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK NO. 1 STEREO JACK ADAPTER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK NO. 1 STEREO JACK ADAPTER ASSEMBLY
a.

Replace the No. 1 stereo jack adapter assembly with a new or known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO JACK ADAPTER ASSEMBLY>REMOVAL


b.

Check if the problem symptom recurs.


Result:
Result Proceed to
Malfunction disappears A
Malfunction occurs B



A

END (NO. 1 STEREO JACK ADAPTER ASSEMBLY MALFUNCTIO)

B