This DTC is stored when the stereo component amplifier assembly detects an open in the sub-woofer speaker circuit by energizing the speaker line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1ADF71 | Sub Woofer Speaker Cable Actuator Stuck | Open in the sub-woofer speaker circuit is detected.
(1 trip detection logic) |
·
Harness or connector ·
Stereo component amplifier assembly ·
No. 1 speaker with box assembly |
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the M74 No. 1 speaker with box assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-15 (WFR+) - M74-3 (WF+) | Always | Below 1 Ω |
| F75-30 (WFR-) - M74-2 (WF-) | Always | Below 1 Ω |
| F75-8 (WFL+) - M74-4 (WF+) | Always | Below 1 Ω |
| F75-23 (WFL-) - M74-1 (WF-) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
In accordance with the display of the GTS, perform a speaker circuit energization inspection.
| Tester Display |
|---|
| Speaker Line Electricity Check |
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1ADF71 is output | B |
A
B