The telephone microphone assembly is connected to the radio and display receiver assembly via voice recognition microphone 1 signal detection line.
This DTC is stored when the radio and display receiver assembly detects disconnection of telephone microphone assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B157913 | Voice Recognition Microphone1 Circuit Open | Voice recognition microphone 1 terminal (SNS) disconnected
(2 trip detection logic) |
·
Map light assembly (telephone microphone assembly) ·
Radio and display receiver assembly ·
Harness or connector |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Disconnect the R2 map light assembly (telephone microphone assembly) connector.
Disconnect the F174 radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R2-1 (SNS2) - F174-25 (SNS) | Always | Below 1 Ω |
| R2-7 (MCO-) - F174-22 (MIN-) | Always | Below 1 Ω |
| R2-1 (SNS2) or F174-25 (SNS) - Body ground | Always | 10 kΩ or higher |
| R2-7 (MCO-) or F174-22 (MIN-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
With the radio and display receiver assembly connectors connected, disconnect the R2 map light assembly (telephone microphone assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| R2-7 (MCO-) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
| *a | Component without harness connected
(Map Light Assembly (Telephone Microphone Assembly)) |
Remove the map light assembly (telephone microphone assembly).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (SNS2) - 7 (MCO-) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
NG