Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall with Dual Knob Type Radio and Display) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _084041 TELEMATICS _0524446 TELEMATICS SYSTEM(for eCall with Dual Knob Type Radio and Display) C

TELEMATICS  TELEMATICS SYSTEM(for eCall with Dual Knob Type Radio and Display)  B15F0  VIN Not Programmed or Mismatch - DCM  


DESCRIPTION

This DTC is stored when the Vehicle Identification Number (VIN) is not stored in the telematics transceiver or when the VIN stored in the telematics transceiver and the VIN stored in the ECM do not match.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15F0 VIN Not Programmed or Mismatch - DCM When either of the following conditions is met for 7.5 seconds or more:
·

The VIN is not stored in the telematics transceiver

·

The VIN stored in the telematics transceiver and the VIN stored in the ECM do not match


·

SFI system

·

CAN communication system



PROCEDURE

1.REGISTER VIN
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and wait for 20 seconds.


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Telematics / Utility / Vin Synchronization

Body Electrical > Telematics > Utility
Tester Display
VIN Synchronization
50005 233 2391

f.

According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Turn the power switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the power switch on (IG) and wait for 20 seconds.


d.

Turn the GTS on.


e.

f.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall with Dual Knob Type Radio and Display)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

3.CHECK CAN COMMUNICATION SYSTEM
3.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

OK:

CAN communication system DTCs are not output.



Result:
Result Proceed to
OK (for 2ZR-FXE) A
OK (for M20AFXS) B
NG C



A

B

C