Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type with Dual Knob Type) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0524476 NAVIGATION SYSTEM(for Radio and Display Type with Dual Knob Type) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type with Dual Knob Type)  B1585  USB Device Malfunction  


DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1585 USB Device Malfunction USB Device Malfunction
·

Non mass-storage class or incompatible protocol USB device

·

USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT)

·

"iPod" malfunction

·

"iPod" with unsupported firmware

·

Unsupported "iPod" model


·

USB device or "iPod"

·

Radio and display receiver assembly



DTC Detection Conditions
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3 Pattern 4 Pattern 5
Diagnosis Condition - - - - - -
Malfunction Status A non mass-storage class or incompatible protocol USB device is connected ○ - - - -
USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) is connected - ○ - - -
"iPod" malfunction - - ○ - -
"iPod" with unsupported firmware is connected - - - ○ -
Unsupported "iPod" model is connected - - - - ○
Detection Time - - - - -
Number of Trips 1 trip 1 trip 1 trip 1 trip 1 trip

PROCEDURE

1.REPLACE USB DEVICE OR "iPod"
a.

Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.


b.

Turn the power switch off.

HINT:

When this DTC has been stored, it is necessary to turn off the power switch to make it possible for the vehicle to recognize a new device when it is connected.



c.

Turn the power switch on (ACC).


d.

Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:
·

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.




Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" WAS DEFECTIVE

NG