Check that the voice guidance setting is not off.
Voice guidance setting is not off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the n1*1 or F167*2 radio and display receiver assembly connector.
Disconnect the n2*1 or F168*2 navigation ECU connector.
*1: for TMMT Made
*2: for TMC Made
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| n1-22 (SI+) - n2-6 (VOI+) | Always | Below 1 Ω |
| n1-23 (SI-) - n2-7 (VOI-) | Always | Below 1 Ω |
| n1-22 (SI+) or n2-6 (VOI+) - Body ground | Always | 10 kΩ or higher |
| n1-23 (SI-) or n2-7 (VOI-) - Body ground | Always | 10 kΩ or higher |
| n2-8 (SLD1) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F167-22 (SI+) - F168-6 (VOI+) | Always | Below 1 Ω |
| F167-23 (SI-) - F168-7 (VOI-) | Always | Below 1 Ω |
| F167-22 (SI+) or F168-6 (VOI+) - Body ground | Always | 10 kΩ or higher |
| F167-23 (SI-) or F168-7 (VOI-) - Body ground | Always | 10 kΩ or higher |
| F168-8 (SLD1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG