Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type with Dual Knob Type) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _061290 NAVIGATION / MULTI INFO DISPLAY _0524476 NAVIGATION SYSTEM(for Radio and Display Type with Dual Knob Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type with Dual Knob Type)  Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU  


DESCRIPTION

This circuit includes the navigation ECU and radio and display receiver assembly.

WIRING DIAGRAM

E367997E60
1.292,0.896 1.896,1.167 0.604,0.271 10 false REV2 1.76,0.781 2.365,1.052 0.604,0.271 10 false 19 5.313,0.781 5.917,1.052 0.604,0.271 10 false 28 0.771,1.781 2.052,2.021 1.281,0.24 10 false n2*1, F168*2 0.771,1.938 1.833,2.229 1.063,0.292 10 false Navigation ECU 5.5,1.781 6.844,2.021 1.344,0.24 10 false n1*1, F167*2 5.5,1.948 6.74,2.313 1.24,0.365 10 false Radio and Display Receiver Assembly 5.573,0.885 6.177,1.156 0.604,0.271 10 false REV2 2.052,2.427 3.792,2.792 1.74,0.365 10 false *1: for TMMT made 3.521,2.427 5.26,2.792 1.74,0.365 10 false *2: for TMC made

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the n1*1 or F167*2 radio and display receiver assembly connector.


b.

Disconnect the n2*1 or F168*2 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

*1: for TMMT Made

*2: for TMC Made


Standard Resistance:
for TMMT Made
Tester Connection Condition Specified Condition
n1-28 (REV2) - n2-19 (REV2) Always Below 1 Ω
n1-28 (REV2) or n2-19 (REV2) - Body ground Always 10 kΩ or higher


for TMC Made
Tester Connection Condition Specified Condition
F167-28 (REV2) - F168-19 (REV2) Always Below 1 Ω
F167-28 (REV2) or F168-19 (REV2) - Body ground Always 10 kΩ or higher


Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR