This circuit includes the navigation ECU and radio and display receiver assembly.
Disconnect the n1*1 or F167*2 radio and display receiver assembly connector.
Disconnect the n2*1 or F168*2 navigation ECU connector.
Measure the resistance according to the value(s) in the table below.
*1: for TMMT Made
*2: for TMC Made
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| n1-7 (SUP) - n2-21 (SUP) | Always | Below 1 Ω |
| n1-7 (SUP) or n2-21 (SUP) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F167-7 (SUP) - F168-21 (SUP) | Always | Below 1 Ω |
| F167-7 (SUP) or F168-21 (SUP) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG