Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall with Single Knob Type Radio and Display) › from 2022.01
RM32K0E _56 Audio / Visual / Telematics _084041 TELEMATICS _0524469 TELEMATICS SYSTEM(for eCall with Single Knob Type Radio and Display) D

TELEMATICS  TELEMATICS SYSTEM(for eCall with Single Knob Type Radio and Display)  OPERATION CHECK  


ENTER TEST MODE


HINT:
·

By performing a system check, it is possible to check the operation of the telephone transceiver assembly.

·

Make sure to perform a test mode after troubleshooting the telematics system.



a.

Turn the ignition switch to ON and wait for 60 seconds with the vehicle stopped.


b.

Turn the taillights on and off at an interval of 10 seconds or less as follows:

HINT:
·

These operations should be performed 10 times or more, until both the red and green indicator lights of the mayday switch assembly are flashing.

·

Turning the taillights on and off can be confirmed by the dimming of the green indicator of the mayday switch assembly.



for Light Control Switch without Off Position:

With the automatic light control sensor exposed to light, turn the light control switch from "AUTO" to "Tail" and back again repeatedly.

(Example: AUTO → Tail → AUTO → Tail . . . .)


for Light Control Switch without Off Position (if the above procedure cannot be completed successfully):

With the automatic light control sensor exposed to light, use an opaque cover to repeatedly cover and uncover the automatic light control sensor.

(Example: Uncover → Cover → Uncover → Cover . . . .)



c.
E338332C03
1.094,1.927 1.344,1.927 1.344,1.927 1.344,1.51 true 2.354,1.927 2.104,1.927 2.104,1.927 2.104,1.51 true 0.875,1.833 1.115,2.063 0.24,0.229 10 false *a 2.417,1.844 2.656,2.073 0.24,0.229 10 false *b
*a Mayday Switch Assembly Green Indicator
*b Mayday Switch Assembly Red Indicator


Check that the mayday switch assembly indicators begin blinks 5 times over 10 seconds and the turn off. Push the mayday switch assembly for less than 3 seconds within 15 seconds after the indicators begin to blink to enter test mode.



PERFORM SYSTEM CHECK


a.

Enter test mode.

HINT:

The mayday switch assembly indicator (green) will blink 3 times to indicate that test mode has been entered.



b.

Speak into the communication telematics box and confirm that your voice can be heard from the communication telematics box.