These DTCs are stored when a malfunction occurs in the radio and display receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B155096 | DAB Tuner Component Internal Failure | When any of the following conditions is met:
(2 trip detection logic) ·
DAB control network malfunction ·
DAB-NAVI communication malfunction ·
RF module malfunction ·
OFDM malfunction ·
Decoder malfunction ·
Memory malfunction ·
Audio output malfunction |
Radio and display receiver assembly |
| B158D87 | Video Signal Stoppage Missing Message | A component internal image signal communication malfunction is detected
(2 trip detection logic) |
Radio and display receiver assembly |
| B15A096 | LAN Master Component Internal Failure | When any of the following conditions is met:
(2 trip detection logic) ·
Bus malfunction ·
Internal power source malfunction ·
Internal hardware malfunction ·
DSP malfunction ·
EEPROM malfunction ·
Storage malfunction |
Radio and display receiver assembly |
| B15B396 | Radio Tuner Component Internal Failure | A radio tuner internal communication malfunction is detected
(2 trip detection logic) |
Radio and display receiver assembly |
| B15B796 | Bluetooth Module Component Internal Failure | A "Bluetooth" module internal malfunction is detected
(2 trip detection logic) |
Radio and display receiver assembly |
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Clear the DTCs.
Turn the ignition switch off.
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B155096, B158D87, B15A096, B15B396 or B15B796 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL