This DTC is stored when the radio and display receiver assembly detects an open in the front speaker RH circuit by energizing the speaker line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1ACA71 | Front Right Speaker Cable Actuator Stuck | Open in the front speaker RH circuit is detected.
(1 trip detection logic) |
·
Harness or connector ·
Front No. 1 speaker assembly RH ·
Front No. 2 speaker assembly RH ·
Front No. 3 speaker assembly RH*2 ·
Radio and display receiver assembly*1 ·
Stereo component amplifier assembly*2 |
*1: for 6 Speakers
*2: for 9 Speakers
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 6 Speakers | A |
| for 9 Speakers | B |
A
B
Disconnect the F132 radio and display receiver assembly connector.
Disconnect the I13 front No. 1 speaker assembly RH connector.
Disconnect the F85 front No. 2 speaker assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F132-1 (FR+) - F85-4 (TWR+) | Always | Below 1 Ω |
| F132-6 (FR-) - F85-2 (TWR-) | Always | Below 1 Ω |
| I13-2 - F85-3 (+) | Always | Below 1 Ω |
| I13-1 - F85-1 (-) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
In accordance with the display of the GTS, perform a speaker circuit energization inspection.
| Tester Display |
|---|
| Speaker Line Electricity Check |
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1ACA71 is output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the I13 front No. 1 speaker assembly RH connector.
Disconnect the F52 front No. 2 speaker assembly RH connector.
Disconnect the F89 front No. 3 speaker assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-12 (FR+) - F89-2 (TWR+) | Always | Below 1 Ω |
| F75-27 (FR-) - F89-4 (TWR-) | Always | Below 1 Ω |
| I13-2 - F89-1 (+) | Always | Below 1 Ω |
| I13-1 - F89-3 (-) | Always | Below 1 Ω |
| F75-14 (TWR+) - F52-2 | Always | Below 1 Ω |
| F75-29 (TWR-) - F52-1 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
In accordance with the display of the GTS, perform a speaker circuit energization inspection.
| Tester Display |
|---|
| Speaker Line Electricity Check |
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1ACA71 is output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL