This DTC is stored when the radio and display receiver assembly detects an open in the rear speaker RH circuit by energizing the speaker line.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1ACC71 | Rear Door Right Speaker Cable Actuator Stuck | Open in the rear speaker RH circuit is detected.
(1 trip detection logic) |
·
Harness or connector ·
Radio and display receiver assembly*1 ·
Stereo component amplifier assembly*2 ·
Rear speaker assembly RH |
*1: for 6 Speakers
*2: for 9 Speakers
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 6 Speakers | A |
| for 9 Speakers | B |
A
B
Disconnect the F132 radio and display receiver assembly connector.
Disconnect the K5 rear speaker assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F132-4 (RR+) - K5-2 | Always | Below 1 Ω |
| F132-9 (RR-) - K5-1 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
In accordance with the display of the GTS, perform a speaker circuit energization inspection.
| Tester Display |
|---|
| Speaker Line Electricity Check |
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1ACC71 is output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
Disconnect the F75 stereo component amplifier assembly connector.
Disconnect the K5 rear speaker assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F75-13 (RR+) - K5-2 | Always | Below 1 Ω |
| F75-28 (RR-) - K5-1 | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
In accordance with the display of the GTS, perform a speaker circuit energization inspection.
| Tester Display |
|---|
| Speaker Line Electricity Check |
Check for DTCs and proceed to the following step.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC B1ACC71 is output | B |
A
B
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL