The audio and visual system communicates with each device via AVC-LAN communication. If a malfunction such as a short in a communication line, short to +B or short to ground occurs in the AVC-LAN circuit, communication will stop and the audio and visual system will not operate correctly. The malfunctioning device can be identified if the system returns to normal when the malfunctioning device is disconnected from the AVC-LAN circuit.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Disconnect the connector of each dealer installed optional device (AVC-LAN compatible device) and check if the malfunction continues.
| Result | Proceed to |
|---|---|
| No dealer installed optional devices are installed | A |
| The malfunction reoccurs | |
| The system returns to normal | B |
A
B
Remove the radio and display receiver assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
| *a | Component without harness connected
(Radio and Display Receiver Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1(TX1+) - 2(TX1-) | Always | 60 to 80 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
Disconnect the F174 radio and display receiver assembly connector.
Disconnect the F152 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F174-1(TX1+) - F152-8(TX+) | Always | Below 1 Ω |
| F174-2(TX1-) - F152-7(TX-) | Always | Below 1 Ω |
| F174-1(TX1+) or F152-8(TX+) - Body ground | Always | 10 kΩ or higher |
| F174-2(TX1-) or F152-7(TX-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the connector of each AVC-LAN connected device and check if the malfunction continues.
| Result | Proceed to |
|---|---|
| The malfunction continues | A |
| The system returns to normal (AVC-LAN connected device was malfunctioning) | B |
A
B
| *a | Component with harness connected
(Radio and Display Receiver Assembly ) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| D174-1(TX1+) - F174-2(TX1-) | ACC ON | Approximately 0 V |
| F174-1(TX1+) - Body ground | ACC ON | Approximately 2.5 V |
| F174-2(TX1-) - Body ground | ACC ON | Approximately 2.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>RADIO RECEIVER (for Radio and Display Type)>REMOVAL
NG