Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2022.01
RM32K0E _58 Vehicle Interior _062267 SUPPLEMENTAL RESTRAINT SYSTEMS _0304666 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  SYSTEM DESCRIPTION  


GENERAL


a.

Acceleration sensors and pressure sensors used for the airbag system are installed to various parts on the vehicle and calculate the acceleration rate and pressure of each part during a collision.


b.

Depending on the situation, the airbag sensor assembly sends a deployment signal to SRS parts based on the information from each sensor.



DEPLOYMENT CONDITION


a.

FRONTAL COLLISION

C341622E12
0.365,0.281 2.177,0.667 1.813,0.385 10 false Airbag Sensor Assembly 0.531,1.208 1.979,1.615 1.448,0.406 10 false Front Airbag Sensor 3.052,0.813 3.719,1.115 0.667,0.302 10 false AND 5.677,0.813 6.51,1.063 0.833,0.25 10 false to SRS Parts 3.781,0.917 5.146,1.365 1.365,0.448 10 false Deployment Signals

i.

Frontal collision signals are produced based on the information from the airbag sensor assembly and front airbag sensors.

HINT:

In the case of a frontal collision, the SRS deployment signal may be output after receiving an ON signal from the acceleration sensor built into the airbag sensor assembly even without a signal from the front airbag sensors.



ii.

Frontal collision signals are used to deploy the SRS parts.

SRS Part Pretensioner Deployment Judgment Pretensioner and Airbag Deployment Judgment
Horn Button Assembly Driver Side Squib X ○
Driver Side Squib 2nd Step (w/ Dual-stage SRS) X ○*1
Instrument Panel Passenger without Door Airbag Assembly X ○*2
Lower No. 1 Instrument Panel Airbag Assembly (w/ Dual-stage SRS) X ○
Front Seat Airbag Assembly LH X X
Front Seat Airbag Assembly RH X X
Curtain Shield Airbag Assembly LH X ○
Curtain Shield Airbag Assembly RH X ○
Front Seat Outer Belt Assembly LH ○ ○
Front Seat Outer Belt Assembly RH ○ ○
Rear Seat 3 Point Type Outer Belt Assembly LH (w/ Rear Pretensioner) ○ ○
Rear Seat 3 Point Type Outer Belt Assembly RH (w/ Rear Pretensioner) ○ ○

○: Deployable

X: Not Deployable

*1: Deployment depends on of driver seat belt condition and seat position.

*2: Deployment depends on airbag cut off switch cylinder sub-assembly condition. (w/ Airbag Cut Off Switch)




b.

SIDE COLLISION

C398646E02
3.25,1.115 3.667,1.385 0.417,0.271 10 false AND 0.333,0.385 2.583,0.719 2.25,0.333 10 false Door Side Airbag Sensor 3.979,1.26 5.396,1.615 1.417,0.354 10 false Deployment Signals 5.979,1.125 7.031,1.458 1.052,0.333 10 false to SRS Parts 0.333,1.063 2.583,1.396 2.25,0.333 10 false Floor Side Airbag Sensor 0.333,1.729 2.583,2.063 2.25,0.333 10 false Airbag Sensor Assembly

i.

Side collision signals are produced based on the information from the airbag sensor assembly, door side airbag sensor and floor side airbag sensor.


ii.

Side collision signals are used to deploy the SRS parts.

SRS Part Side Collision (Pattern 1) Detected
LH Side Collision RH Side Collision
Horn Button Assembly Driver Side Squib X X
Driver Side Squib 2nd Step (w/ Dual-stage SRS) X X
Instrument Panel Passenger without Door Airbag Assembly X X
Lower No. 1 Instrument Panel Airbag Assembly (w/ Dual-stage SRS) X X
Front Seat Airbag Assembly LH ○ X
Front Seat Airbag Assembly RH X ○
Curtain Shield Airbag Assembly LH ○ X
Curtain Shield Airbag Assembly RH X ○
Front Seat Outer Belt Assembly LH ○ ○
Front Seat Outer Belt Assembly RH ○ ○
Rear Seat 3 Point Type Outer Belt Assembly LH (w/ Rear Pretensioner) ○ ○
Rear Seat 3 Point Type Outer Belt Assembly RH (w/ Rear Pretensioner) ○ ○

○: Deployable

X: Not Deployable