Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2022.01
RM32K0E _58 Vehicle Interior _062267 SUPPLEMENTAL RESTRAINT SYSTEMS _0304666 AIRBAG SYSTEM C

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  B167A  Front Door Pressure Sensor LH  B167E  Front Door Pressure Sensor Threshold Malfunction (LH)  


DESCRIPTION

The side collision sensor LH circuit (bus 1) consists of the airbag sensor assembly and door side airbag sensor LH.

The door side airbag sensor LH detect impacts to the vehicle and send signals to the airbag sensor assembly to determine if the airbags and pretensioners should be deployed.

These DTCs are stored when a malfunction is detected in the door side airbag sensor LH.

DTC No. Detection Item DTC Detection Condition Trouble Area Test Mode / Check Mode
B167A Front Door Pressure Sensor LH
·

Door side airbag sensor LH malfunction

·

Airbag sensor assembly malfunction


·

Door side airbag sensor LH

·

Airbag sensor assembly


Does not apply to test/check mode
B167E Front Door Pressure Sensor Threshold Malfunction (LH)
·

Door side airbag sensor LH malfunction

·

Airbag sensor assembly malfunction


·

Door side airbag sensor LH

·

Airbag sensor assembly


Does not apply to test/check mode

DTC Detection Conditions (B167A):
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Power switch on (IG) ○ ○
Malfunction Status Door side airbag sensor LH malfunction ○ -
Airbag sensor assembly malfunction - ○
Detection Time - -
Number of Trips 1 trip 1 trip

DTC Detection Conditions (B167E):
Vehicle Condition
Pattern 1 Pattern 2
Diagnosis Condition Power switch on (IG) ○ ○
Malfunction Status Door side airbag sensor LH malfunction ○ -
Airbag sensor assembly malfunction - ○
Detection Time - -
Number of Trips 1 trip 1 trip

HINT:

DTC will be output when conditions for either of the patterns in the table above are met.


CAUTION / NOTICE / HINT

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

1.CHECK DOOR SIDE AIRBAG SENSOR LH
a.
E449100C02
0.5,0.531 0.813,0.729 0.313,0.198 10 false *1 2.479,0.844 2.792,1.042 0.313,0.198 10 false *2
*1 Door Side Airbag Sensor RH
*2 Airbag Sensor Assembly


Turn the power switch off.


b.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Interchange the door side airbag sensor LH with RH and connect the connectors.


d.

Connect the cable to the negative (-) battery terminal.


e.

Turn the power switch on (IG), and wait for at least 60 seconds.


f.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs
50002 188

g.

Turn the power switch off.


h.

Turn the power switch on (IG), and wait for at least 60 seconds.


i.

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes
50001 188
HINT:

Codes other than DTCs B166C, B166F, B167A and B167E may be output at this time, but they are not related to this check.



Result:
Result Proceed to
DTC B167A or B167E is output. A
DTC B166C or B166F is output. B
DTCs B166C, B166F, B167A and B167E are not output. C


j.

Turn the power switch off.


k.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



l.

Return the door side airbag sensor LH and RH to their original positions and connect the connectors.



A

B

C