Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
| *A | for AWD | - | - |
| *1 | NO. 1 BACK DOOR EMBLEM | *2 | NO. 1 BACK DOOR NAME PLATE |
| *3 | NO. 2 BACK DOOR NAME PLATE | *4 | NO. 4 BACK DOOR NAME PLATE |
| ● | Non-reusable part | - | - |
NO. 1 BACK DOOR EMBLEM
| *a | Location Pin |
NO. 1 BACK DOOR NAME PLATE
| *a | Reference Values | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 57.0 mm (2.24 in.) | B | 85.5 mm (3.37 in.) |
| C | 83.2 mm (3.28 in.) | - | - |
NO. 2 BACK DOOR NAME PLATE
| *a | Reference Values | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 65.1 mm (2.56 in.) | B | 113.7 mm (4.48 in.) |
NO. 4 BACK DOOR NAME PLATE (for AWD)
| *a | Reference Values | - | - |
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 115.9 mm (4.56 in.) | B | 22.4 mm (0.88 in.) |
| C | 23.9 mm (0.94 in.) | - | - |