Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2016.10–2019.09
BM32H0E _V1 General _060351 INTRODUCTION _0295857 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED / RECONNECTED  


Refer to the TOYOTA Repair Manual for each work procedure.

PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function when Necessary Procedures not Performed
Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

*1: When performing learning using the GTS

*2: w/ Stop and start system


NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal (for Audio and Visual System).

·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal (for Navigation System (for Radio and Display Type)).