Home › Vehicle Exterior › BODY DIMENSIONS › REAR SUSPENSION CROSSMEMBER(for AWD)
BM32H0E _01 Vehicle Exterior _060352 BODY DIMENSIONS _0298260 REAR SUSPENSION CROSSMEMBER(for AWD) F

BODY DIMENSIONS  REAR SUSPENSION CROSSMEMBER(for AWD)  TWO-DIMENSIONAL DISTANCE  


HINT:
·

Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

·

In cases in which only one dimension is given, left and right are symmetrical.

·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A, a Rear Suspension Crossmember Installation Hole φ24 (0.94)
B, b Rear Suspension No. 1 Lower Arm Installation Hole φ12.2 (0.48)
C, c Rear Suspension Upper Arm Installation Hole φ12.2 (0.48)
D, d Rear Suspension No. 2 Lower Arm Installation Hole 23.1X14.2
(0.91X0.56)
E, e Lower Arm Rear Suspension Reinforcement Standard Hole φ10 (0.39)
F, f Rear Suspension Crossmember Installation Hole φ24 (0.94)

K138072C01
3.49,1.104 3.802,1.26 0.313,0.156 10 false *A 4.219,1.729 4.531,1.885 0.313,0.156 10 false *B 2.781,1.729 3.094,1.885 0.313,0.156 10 false *C 0.146,8.667 0.458,8.823 0.313,0.156 10 false *a
*A FRONT *B LH
*C RH - -
*a mm
(in.)
- -


K138073C01
2.781,2.333 3.094,2.49 0.313,0.156 10 false *A 4.208,2.333 4.521,2.49 0.313,0.156 10 false *B 0.823,5.542 1.135,5.698 0.313,0.156 10 false *a 1.219,6.125 1.531,6.281 0.313,0.156 10 false *b 0.167,8.667 0.479,8.823 0.313,0.156 10 false *c
*A LH *B RH
*a Imaginary Datum Line *b Height from Imaginary Datum Line
*c mm
(in.)
- -