Home › Vehicle Exterior › BODY PANEL › FRONT SIDE MEMBER(for TMMT Made)
BM32H0E _01 Vehicle Exterior _060349 BODY PANEL _0301059 FRONT SIDE MEMBER(for TMMT Made) F

BODY PANEL  FRONT SIDE MEMBER(for TMMT Made)  ASSEMBLY REPLACEMENT  


K138022

With the front fender apron assembly removed.


REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108826

Cut with Disc Sander etc.

a.

After removing the A, remove the front side member sub-assembly and the rear side member sub-assembly.

K137629C01
2.115,1.531 2.823,0.969 2.823,0.969 2.99,0.969 false 5.802,0.906 5.906,0.344 5.906,0.344 6.073,0.344 false 4.542,3.323 4.656,3.323 4.656,3.323 4.76,2.51 false 3.042,0.875 3.198,1.073 0.156,0.198 10 false A 6.115,0.229 6.427,0.385 0.313,0.156 10 false *1 4.375,3.219 4.688,3.375 0.313,0.156 10 false *2
*1 FRONT SIDE MEMBER SUB-ASSEMBLY *2 REAR SIDE MEMBER SUB-ASSEMBLY


K137630

K137631



INSTALLATION


Symbol Meaning
K108818

Remove Weld Points
K108823

Plug Weld

a.

Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)


b.

Make sure to attach correctly in accordance with the body dimension diagram as this part affects the front wheel alignment.


c.

Remove A from the new parts.

K140517C01
3.792,1.448 4.188,1.094 4.188,1.094 4.323,1.094 false 2.458,0.979 2.333,0.427 2.333,0.427 2.208,0.427 false 4.375,1 4.531,1.198 0.156,0.198 10 false A 2.042,0.323 2.354,0.479 0.313,0.156 10 false *1
*1 REAR SIDE MEMBER SUB-ASSEMBLY - -



d.

Before temporarily installing the new parts, weld the front side member sub-assembly and the rear side member sub-assembly with the standard number of welding points.

K140521C02
4.177,2.521 4.031,2.521 4.031,2.521 3.885,2.156 false 1.604,1.781 1.417,1.781 1.417,1.781 1.292,1.042 false 1.635,1.677 1.948,1.833 0.313,0.156 10 false *1 4.208,2.427 4.521,2.583 0.313,0.156 10 false *2
*1 FRONT SIDE MEMBER SUB-ASSEMBLY *2 REAR SIDE MEMBER SUB-ASSEMBLY


K137633

K137634


e.

Weld the A to the vehicle side.

K137635N01
2.135,1.552 2.927,0.938 2.927,0.938 3.063,0.938 false 3.125,0.844 3.281,1.042 0.156,0.198 10 false A


f.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)


g.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.