Home › Power Source / Network › NETWORKING › CAN COMMUNICATION SYSTEM
NM32H0E _57 Power Source / Network _059736 NETWORKING _0292859 CAN COMMUNICATION SYSTEM GE GENERAL F

NETWORKING  CAN COMMUNICATION SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

The Controller Area Network (CAN) is a serial data communication network for real time application. It is a multiplex communication network equipped in a vehicle, and has communication speeds of 500 kbps (HS-CAN), and the ability to detect malfunctions.


b.

The HS-CAN consists of the V bus, bus 1, bus 2, bus 3, bus 4, bus 5 and local bus.


c.

The communication wire used is a twisted-pair wire. The bus line has a high line (2.5 V to 3.5 V of voltage is applied) and a low line (1.5 V to 2.5 V of voltage is applied).


d.

The terminating resistors for each bus are located as shown in the following table.

Bus Terminating Resistor Location
CAN V Bus Central Gateway ECU (Network Gateway ECU)
CAN Bus 1 Central Gateway ECU (Network Gateway ECU)
CAN Bus 2
·

Central Gateway ECU (Network Gateway ECU)

·

ECM


CAN Bus 3 Central Gateway ECU (Network Gateway ECU)
CAN Bus 4
·

Central Gateway ECU (Network Gateway ECU)

·

Airbag Sensor Assembly


CAN Bus 5
·

Central Gateway ECU (Network Gateway ECU)

·

Combination Meter Assembly