Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL SYSTEM
NM32H0E _52 Drivetrain _059756 AXLE AND DIFFERENTIAL _0292885 DIFFERENTIAL SYSTEM DE DETAILS F

AXLE AND DIFFERENTIAL  DIFFERENTIAL SYSTEM  DETAILS  FRONT DIFFERENTIAL  


CONSTRUCTION


a.

Differential Pre-torque Mechanism (Models with Manual Transaxle or 3ZR-FAE Engine)

i.

A conical spring is provided between the side gear and the side gear thrust washer in the differential. The load of the conical spring applies a friction force to the sliding area, enhancing the straight-line stability and steering stability.

X114625C03
2.781,0.302 3.031,0.302 3.031,0.302 3.51,0.875 true 2.302,1.302 2.927,1.302 true 2.323,0.979 3.406,0.979 true 3.927,0.563 4.552,0.563 true 2.625,0.219 2.938,0.375 0.313,0.156 10 false *1 2.125,0.906 2.438,1.063 0.313,0.156 10 false *2 2.115,1.219 2.427,1.375 0.313,0.156 10 false *3 4.625,0.49 4.938,0.646 0.313,0.156 10 false *4 3.844,5.5 4.156,5.656 0.313,0.156 10 false *a 0.125,5.531 0.438,5.688 0.313,0.156 10 false *b
*1 Side Gear Thrust Washer *2 Conical Spring
*3 Side Gear *4 Differential Case
*a Front Differential Case Sub-assembly Cross Section *b This illustration is an example only.





OPERATION


a.

Under light load and low differential rotation speeds, due to the friction force of the sliding area, differential limit torque for the left and right wheels is achieved within the range of the conical spring allowable load. At middle and high load ranges, which are beyond the allowable load of the conical spring, the system performs as an open differential.