CONSTRUCTION
A high-pressure injector with multiple injection holes (6-hole type) in which the injection angle is optimized and fuel is highly atomized is used. (Models with GPF)
A 1-hole type high pressure slit nozzle fuel injector assembly, which has 1 injection hole shaped like a slit, is used. (Models without GPF)
The use of this fuel injector assembly causes the fuel to become highly atomized and spread over a wide fan-shaped area. At the same time, the fuel is mixed with a large amount of air and injected into the combustion chamber. As a result, fuel injection dissipation performance is improved to achieve a homogeneous air-fuel mixture, high performance and high engine output.
A Teflon sealant is used for the cylinder internal pressure sealant and an insulator is used at the cylinder head sub-assembly contact area to reduce vibration and noise and improve sealing performance.
An O-ring and backup ring* are used in the fuel injector assembly. As a result, the transmission of operation noise from the fuel injector assembly is reduced to improve quietness and ensure fastener airtightness.
*: The backup ring is installed to securely support the rubber O-ring, which is subjected to high pressures. Take care to install the backup ring in the correct direction at the correct installation position.
| *1 | O-ring | *2 | Backup Ring |
| *3 | Insulator | *4 | Teflon Sealant |
| *a | Fuel Injector Assembly Cross Section | *b | Injection Hole |
| *1 | O-ring | *2 | Backup Ring |
| *3 | Insulator | *4 | Teflon Sealant |
| *a | Fuel Injector Assembly Cross Section | *b | Injection Hole |