OUTLINE
Exhaust Emission Control System (Models with GPF)
A Three-Way Catalytic converter (TWC) and a Gasoline Particulate Filter (GPF) are used to reduce gas emissions.
The exhaust manifold converter sub-assembly is positioned directly below the turbocharger sub-assembly to improve TWC warm-up performance.
Precise air-fuel ratio control is made possible by 2 air fuel ratio sensors, positioned upstream and downstream of the TWC in the exhaust manifold converter sub-assembly.
Based on the signals from the air fuel ratio sensor (bank 1, sensor 1) and No. 2 air fuel ratio sensor (bank 1, sensor 2), the ECM controls the fuel injection volume in order to optimize the emissions in the exhaust gas.
An air fuel ratio sensor heater control, which maintain the temperature of the respective air fuel ratio sensors at an appropriate level, are used to improve the detection accuracy of oxygen concentration in exhaust gas.
Exhaust Emission Control System (Models without GPF)
Three-Way Catalytic converters (TWCs) are used to reduce gas emissions.
The exhaust manifold converter sub-assembly is positioned directly below the turbocharger sub-assembly to improve TWC warm-up performance.
Precise air-fuel ratio control is made possible by positioning the air fuel ratio sensor (bank 1, sensor 1) upstream of the TWC of the exhaust manifold converter sub-assembly, and positioning the oxygen sensor (bank 1, sensor 2) in the front exhaust pipe assembly.
Based on the signals from the air fuel ratio sensor (bank 1, sensor 1) and oxygen sensor (bank 1, sensor 2), the ECM controls the fuel injection volume in order to optimize the emissions in the exhaust gas.
An air fuel ratio sensor and an oxygen sensor heater control, which maintain the temperature of the respective sensors at an appropriate level, are used to improve the detection accuracy of oxygen concentration in exhaust gas.
Evaporative Emission Control System
The evaporative emission control system prevents the fuel vapor that is created in the fuel tank assembly from being released directly into the atmosphere.
The charcoal canister stores the fuel vapor that has been created in the fuel tank assembly.
This system consists of a purge VSV (No. 1 vacuum switching valve assembly), charcoal canister and ECM.
The ECM controls the purge VSV (No. 1 vacuum switching valve assembly) in accordance with the driving conditions in order to direct the fuel vapor into the engine, where it is burned.
A No. 1 check valve is used between the purge VSV (No. 1 vacuum switching valve assembly) and intake port to prevent intake air from flowing back toward the charcoal canister due to the turbo pressure.
Gasoline Particulate Filter (GPF) System (Models with GPF)
Gasoline Particulate Filter (GPF) system is used for the models compliant with EURO 6d emission regulations to purify Particulate Matter (PM) contained in exhaust gas.