CONSTRUCTION
On models with a Gasoline Particulate Filter (GPF), a thin-wall, high-cell density, ceramic type TWC is used for the exhaust manifold converter sub-assembly.
On 2WD models without a GPF, a thin-wall, high-cell density, ceramic type TWC is used for exhaust manifold converter sub-assembly and a thin-wall, ceramic type TWC is used for the front exhaust pipe assembly.
On AWD models without a GPF, a thin-wall, high-cell density, ceramic type TWC is used for exhaust manifold converter sub-assembly and a thin-wall, ceramic type TWC is used for the center No. 2 exhaust pipe assembly.
An exhaust manifold converter sub-assembly with an integrated TWC is used. This realizes quick warm-up of the catalytic converter, helping to reduce emissions immediately after engine start.
These TWCs enable improved exhaust emissions through optimized cell density and wall thickness.
| *A | Models with GPF | *B | Models without GPF |
| *1 | Exhaust Manifold Converter Sub-assembly
·
TWC |
*2 | Front Exhaust Pipe Assembly
·
GPF |
| *3 | Front Exhaust Pipe Assembly
·
TWC |
- | - |
| *A | Models with GPF | *B | Models without GPF |
| *1 | Exhaust Manifold Converter Sub-assembly
·
TWC |
*2 | Center No. 2 Exhaust Pipe Assembly
·
GPF |
| *3 | Center No. 2 Exhaust Pipe Assembly
·
TWC |
- | - |