CONSTRUCTION
When the ultrasonic sensor transmits ultrasonic waves and receives the reflected waves from an obstacle, the buzzer sounds in stages in accordance with the distance to the obstacles.
Sounding of the No. 1 and No. 2 clearance warning buzzers is controlled by the clearance warning ECU assembly.
| Item | Specification |
|---|---|
|
*: This is the sound pressure level at a position 1 m (3.3 ft.) away from the buzzer itself, not the level where the driver would be sitting (where the sound would actually be heard). |
|
| Operation Frequency [kHz] | 2.4 +/- 0.04 |
| Sound Pressure Level [dB]* | 80 +/- 6 |
| Item | Specification |
|---|---|
|
*: This is the sound pressure level at a position 1 m (3.3 ft.) away from the buzzer itself, not the level where the driver would be sitting (where the sound would actually be heard). |
|
| Operation Frequency [kHz] | 1.0 +/- 0.02 |
| Sound Pressure Level [dB]* | 83 +/- 7 |
OPERATION
Clearance Warning Buzzer Sounding
If a stationary object is detected at longest range, long-range or medium-range, the buzzer sounding interval changes approximately every 100 mm (3.94 in.) according to the distance from the object, and the clearance warning buzzer sounds.
If a stationary object is detected at short-range or shortest range, the clearance warning buzzer sounds continuously.
If both a front sensor and rear sensor detect a stationary object at the same time, both the No. 1 and No. 2 clearance warning buzzers sound independently (based on the front detection distance for No. 1 and the rear detection distance for No. 2).