86652E
1.INSPECT DRIVING SUPPORT BUZZER (PRE-COLLISION CITY BUZZER)
Make sure that there is no looseness in the locking part and connecting part of the connector.
Disconnect the driving support buzzer (pre-collision city buzzer).
Check the connector and terminals for deformation and corrosion.
No deformation or corrosion.
Connect a positive (+) lead from the battery to terminal 1, and a negative (-) lead to terminal 2 of the driving support buzzer (pre-collision city buzzer), and check that the buzzer sounds.
The pre-collision city buzzer sounds.
If the result is not as specified, replace the driving support buzzer (pre-collision city buzzer).