Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR (for AWD) › 2016.10–2019.09
RM32H0E _53 Suspension _059601 REAR SUSPENSION _0292272 REAR STABILIZER BAR(for AWD) A

REAR SUSPENSION  REAR STABILIZER BAR(for AWD)  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 48840A 2.REMOVE REAR STABILIZER LINK ASSEMBLY LH

a.
C365350N01
1.656,1.469 1.813,1.667 0.156,0.198 10 true A 0.979,4.094 1.135,4.292 0.156,0.198 10 true B

Loosen the nut (A) of the rear stabilizer link assembly LH.

HINT:

If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.



b.

Loosen the nut (B) of the rear stabilizer link assembly LH.

NOTICE:

When loosing the nut, keep the bolt from rotating.



c.
C365351C01
1.938,1.458 2.24,1.458 false 2.094,1.802 2.396,1.802 false 2.281,1.344 2.594,1.542 0.313,0.198 10 false *a 2.427,1.688 2.74,1.885 0.313,0.198 10 false *b
*a Wooden Block
*b Jack


Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.

NOTICE:
·

When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

·

Make sure to perform this operation with the vehicle kept as low as possible.




d.
C365350

Remove the bolt, 2 nuts and rear stabilizer link assembly LH.


Hide 48830D 3.REMOVE REAR STABILIZER LINK ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 48812 4.REMOVE REAR STABILIZER BAR

a.
C365352

Remove the 4 bolts, rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings from the rear suspension member sub-assembly.


Hide 48832A 5.REMOVE REAR NO. 1 STABILIZER BAR BRACKET

a.
C365353

Remove the 2 rear No. 1 stabilizer bar brackets from the 2 rear stabilizer bushings.


Hide 48818 6.REMOVE REAR STABILIZER BUSHING

a.
C365354

Remove the 2 rear stabilizer bushings from the rear stabilizer bar.