These DTCs are stored when a communication error occurs between the sensors and ECUs.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0123 | Lost Communication with Yaw Rate Sensor Module | While the vehicle is being driven at 1 km/h or 1 mph or more, a communication error between the yaw rate sensor and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Yaw rate and acceleration sensor (airbag sensor assembly) ·
Forward recognition camera |
| U0129 | Lost Communication with Brake System Control Module | While the ignition switch is ON, a communication error between the skid control ECU and the forward recognition camera is detected for approximately 5 seconds or more. | ·
CAN communication system ·
Skid control ECU (Brake actuator assembly) ·
Forward recognition camera |
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>ROAD SIGN ASSIST SYSTEM>DTC CHECK / CLEAR
Make sure that the DTC detection conditions are met.
If the conditions are not met, the system cannot detect the malfunction.
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>ROAD SIGN ASSIST SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC U0123 and U0129 are not output | A |
| DTC U0123 or U0129 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING