Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM32H0E _55 Steering _059604 STEERING COLUMN _0292296 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not drop the power steering ECU assembly, strike it with tools or subject it to impacts.

·

If the power steering ECU assembly is subjected to an impact, replace it with a new one.

·

Do not pull the wire harness.

·

Do not allow any moisture to come into contact with the power steering ECU assembly.

·

Do not loosen any bolts not mentioned in the procedure.

·

Do not allow any foreign matter to contaminate the power steering ECU assembly.



PROCEDURE

Hide 45254B 1.INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for LHD)

Hide 89650 2.INSTALL POWER STEERING ECU ASSEMBLY (for LHD)

Hide 45254B 3.INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER (for RHD)

Hide 89650 4.INSTALL POWER STEERING ECU ASSEMBLY (for RHD)

Hide 45020B 5.INSTALL STEERING LOCK ACTUATOR ASSEMBLY (w/ Entry and Start System)

HINT:

When replacing the steering lock actuator assembly, refer to the Service Bulletin.


a.
C322179

Install the steering lock actuator assembly with the tapered-head bolt.


b.

Tighten the tapered-head bolt until the bolt head breaks off.


Hide 85432 6.INSTALL KEY INTERLOCK SOLENOID (w/o Entry and Start System)

a.

for CVT:

i.
C324271

Install the key interlock solenoid to the upper steering column bracket assembly with the screw.



Hide 84450 7.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C321964

Install the ignition or starter switch assembly with the 2 screws.


Hide 84052 8.INSTALL UN-LOCK WARNING SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C328407

Engage the 2 claws to install the un-lock warning switch assembly to the upper steering column bracket assembly.


Hide 69057A 9.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY (w/o Entry and Start System)

a.

Make sure that the ignition switch lock cylinder assembly is in the ACC position.


b.

Install the ignition switch lock cylinder assembly.


Hide 10.INSPECT STEERING LOCK OPERATION (w/o Entry and Start System)

a.
C235544

Check that the steering lock mechanism is activated when the key is removed.


b.
C340567

Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

If there is any abnormality, replace the ignition switch lock cylinder assembly.


Hide 45020B 11.INSTALL UPPER STEERING COLUMN BRACKET WITH SWITCH ASSEMBLY (w/o Entry and Start System)

a.
C322178

Install the upper steering column bracket with switch assembly with the tapered-head bolt.


b.

Tighten the tapered-head bolt until the bolt head breaks off.


Hide 89782 12.INSTALL TRANSPONDER KEY COIL (w/o Entry and Start System)