Home › Steering › STEERING COLUMN › STEERING WHEEL
RM32H0E _55 Steering _059604 STEERING COLUMN _0292297 STEERING WHEEL A

STEERING COLUMN  STEERING WHEEL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

·

Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed with the battery connected and the ignition switch ON.

·

Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.



PROCEDURE

Hide 84250A 1.INSTALL STEERING PAD SWITCH ASSEMBLY

Hide 84632 2.INSTALL CRUISE CONTROL MAIN SWITCH

Hide 45186 3.INSTALL LOWER NO. 2 STEERING WHEEL COVER

Hide 4.ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

Hide 84307 5.INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Hide 45100 6.INSTALL STEERING WHEEL ASSEMBLY

a.
C365792C02
1.698,0.656 0.552,0.604 0.552,0.604 1.708,0.469 true 0.344,0.5 0.656,0.656 0.313,0.156 10 false *a
*a Matchmark


Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.


b.

Install the steering wheel assembly set nut.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


c.

w/ steering heater:

i.

Connect the steering heater connector.



d.

Connect the 2 connectors to the spiral cable with sensor sub-assembly.


Hide 7.CHECK STEERING WHEEL CENTER POINT

Hide 45130 8.INSTALL HORN BUTTON ASSEMBLY