Home › Engine / Hybrid System › 3ZR-FAE (ENGINE CONTROL) › SFI SYSTEM
RM32H0E _51 Engine / Hybrid System _059607 3ZR-FAE ENGINE CONTROL _0292315 SFI SYSTEM D

3ZR-FAE ENGINE CONTROL  SFI SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


A103809E88
2.354,0.135 3.229,0.302 0.875,0.167 10 DTC stored 1.271,1.031 2.052,1.208 0.781,0.177 10 0.5 seconds 0.323,1.031 1.104,1.229 0.781,0.198 10 0.5 seconds 0.354,2.792 2.688,2.948 2.333,0.156 10 Freeze frame data which can be read 2.25,1.031 3.031,1.229 0.781,0.198 10 0.5 seconds

The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

HINT:

If it is impossible to replicate the problem even though a DTC is detected, confirm the freeze frame data.


The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

·

3 data sets before the DTC was stored.

·

1 data set when the DTC was stored.

·

1 data set after the DTC was stored.


These data sets can be used to simulate the condition of the vehicle around the time of the occurrence the malfunction. The data may assist in identifying the cause of the malfunction, and judging whether it was temporary or not.


PENDING FREEZE FRAME DATA


HINT:

Pending freeze frame data is stored when a 2 trip DTC is first detected during the first trip.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes
50001 234

e.

Select a DTC in order to display its pending freeze frame data.

HINT:
·

Pending freeze frame data is cleared when any of the following occurs.

-

Using the GTS, the DTCs are cleared.


-

The cable is disconnected from the negative (-) battery terminal.


-

40 trips with the engine fully warmed up have been performed after returning to normal. (Pending freeze frame data will not be cleared by only returning the system to normal.)


·

With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip DTC is detected in the first trip, the old freeze frame data will be replaced with the new data of the newly detected DTC in the next trip.



A407528E01
0.26,0.219 6.823,0.615 6.563,0.396 10 false When a DTC is detected in both the first and second trips but the system returns to normal from the third trip (2 trip logic DTC): 2.073,0.927 2.885,1.177 0.813,0.25 10 false (First Trip) 2.833,0.927 3.781,1.167 0.948,0.24 10 false (Second Trip) 3.76,0.927 4.583,1.167 0.823,0.24 10 false (Third Trip) 4.563,0.927 5.469,1.167 0.906,0.24 10 false (Fourth Trip) 0.167,1.698 1.219,1.927 1.052,0.229 10 false Ignition Switch 1.344,1.542 1.656,1.74 0.313,0.198 10 false ON 1.344,1.896 1.802,2.094 0.458,0.198 10 false Off 1.344,2.521 2.26,2.719 0.917,0.198 10 false Stored 1.344,2.813 1.781,3.156 0.438,0.344 10 false Not Stored 1.344,3.656 2.26,3.854 0.917,0.198 10 false Stored 1.344,3.927 1.781,4.271 0.438,0.344 10 false Not Stored 0.167,2.604 1.156,2.958 0.99,0.354 10 false Pending Freeze Frame Data 0.167,3.75 1.042,4.104 0.875,0.354 10 false Freeze Frame Data 0.396,4.698 2.031,4.927 1.635,0.229 10 false : Malfunction detected 0.385,5.042 2.083,5.281 1.698,0.24 10 false : Malfunction not detected

A393129E03
0.146,0.135 6.521,0.354 6.375,0.219 10 false When 2 trip DTC is first detected in the first trip and another 2 trip DTC is first detected in the second trip: 2.688,0.698 3.365,0.906 0.677,0.208 10 false (First Trip) 1.604,1.771 1.833,1.969 0.229,0.198 10 false Off 3.563,0.708 4.417,0.927 0.854,0.219 10 false (Second Trip) 4.573,0.708 5.271,0.969 0.698,0.26 10 false (Third Trip) 5.5,0.708 6.281,0.938 0.781,0.229 10 false (Fourth Trip) 1.615,1.354 2.094,1.573 0.479,0.219 10 false ON 0.313,2.333 1.313,2.677 1,0.344 10 false Pending Freeze Frame Data A 1.604,2.25 2.083,2.469 0.479,0.219 10 false Stored 1.604,2.531 2.042,2.917 0.438,0.385 10 false Not Stored 1.594,3.208 2.073,3.427 0.479,0.219 10 false Stored 1.594,3.479 2.031,3.865 0.438,0.385 10 false Not Stored 0.385,1.563 1.333,1.75 0.948,0.188 10 false Ignition Switch 0.302,3.281 1.302,3.625 1,0.344 10 false Pending Freeze Frame Data B 0.708,4.156 2.781,4.344 2.073,0.188 10 false : Pending malfunction A detected 0.719,4.635 2.792,4.823 2.073,0.188 10 false : Pending malfunction B detected 0.708,5.135 2.781,5.323 2.073,0.188 10 false : No malfunction detected 4.188,2.917 4.802,3.115 0.615,0.198 10 false Uploaded



LIST OF FREEZE FRAME DATA


Powertrain > Engine and ECT
Tester Display
Vehicle Speed
Engine Speed
Calculate Load
Vehicle Load
MAF
Atmosphere Pressure
MAP
Engine Oil Temperature Sensor
Coolant Temp
Intake Air
Engine Run Time
Initial Engine Coolant Temp
Initial Intake Air Temp
Battery Voltage
Glow Indicator Supported
Glow Indicator
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
Throttle Sensor Volt %
Throttl Sensor #2 Volt %
Throttle Sensor Position
Throttle Motor DUTY
Throttle Air Flow Learning Value(Area 1)
Throttle Air Flow Learning Value(Area 2)
Throttle Air Flow Learning Value(Area 3)
Throttle Air Flow Learning Value(Calculated Value)
Throttle Air Flow Learning Value(Atmosphere Pressure Offset Value)
Throttle Air Flow Learning Prohibit(Intake Air Pressure Malfunction)
Throttle Air Flow Learning Prohibit(Air Fuel Ratio Malfunction)
Throttle Position
N Range Status
ISC Feedback Learning Torque
ISC Total AUXS Torque
ISC Feedback Torque
ISC Feedback Torque(Recent)
ISC AUXS Torque(Alternator)
ISC AUXS Torque(Air Conditioner)
Throttle Air Flow F/B Value
Injector (Port)
Injection Volum (Cylinder1)
Fuel Pump/Speed Status
Current Fuel Type
EVAP (Purge) VSV
Evap Purge Flow
Purge Density Learn Value
EVAP Purge VSV
Purge Cut VSV Duty
Target Air-Fuel Ratio
AF Lambda B1S1
AFS Voltage B1S1
AFS Current B1S1
A/F Heater Duty B1S1
O2S B1S2
O2S Impedance B1S2
O2 Heater B1S2
O2 Heater Curr Val B1S2
Short FT #1
Long FT #1
Total FT #1
Fuel System Status #1
Fuel System Status #2
IGN Advance
Knock Feedback Value
Knock Correct Learn Value
Idle Spark Advn Ctrl #1
Idle Spark Advn Ctrl #2
Idle Spark Advn Ctrl #3
Idle Spark Advn Ctrl #4
VVT Control Status #1
VVT Advance Fail
VALVEMATIC Target Angle
VALVEMATIC Current Angle
VALVEMATIC IG OFF
VALVEMATIC IG ON
VALVEMATIC Cranking
VALVEMATIC bef Warm Up
VALVEMATIC aft Warm Up
VALVEMATIC IDM Hi Temp
VALVEMATIC Low(ACT)
VALVEMATIC High(ACT)
Catalyst Temp B1S1
Catalyst Temp B1S2
Starter Signal
Power Steering Signal
Neutral Position SW Signal
Stop Light Switch
A/C Signal
Closed Throttle Position SW
Fuel Cut Condition
Immobiliser Communication
TC Terminal
Time after DTC Cleared
Distance from DTC Cleared
Warmup Cycle Cleared DTC
Dist Batt Cable Disconnect
IG OFF Elapsed Time
TC and TE1
Total Distance Traveled
Ignition Trig. Count
Cylinder #1 Misfire Count
Cylinder #2 Misfire Count
Cylinder #3 Misfire Count
Cylinder #4 Misfire Count
All Cylinders Misfire Count
Misfire RPM
Misfire Load
Misfire Margin
Catalyst OT MF F/C
Cat OT MF F/C History
Cat OT MF F/C Cylinder#1
Cat OT MF F/C Cylinder#2
Cat OT MF F/C Cylinder#3
Cat OT MF F/C Cylinder#4
Engine Speed (Starter Off)
Starter Count
Run Dist of Previous Trip
Compression Leakage Count
Rough Idle Status
Plural Cylinders Rough Idle
Rough Idle #1
Rough Idle #2
Rough Idle #3
Rough Idle #4
Engine Starting Time
Previous Trip Coolant Temp
Previous Trip Intake Temp
Engine Oil Temperature
Previous Trip Eng Oil Temp
Ambient Temp for A/C
Previous Trip Ambient Temp
Engine Start Hesitation
Low Rev for Eng Start
Fuel Cut Elps Time
A/F Learn Value Idle #1
A/F Learn Value Low #1
A/F Learn Value Mid1 #1
A/F Learn Value Mid2 #1
A/F Learn Value High #1
Alternator Output Duty
Alt Vol - Non Active Test
Alt Vol - Active Test
Electric Fan Motor
Brake Override System
Idle Fuel Cut
FC TAU
Immobiliser Fuel Cut
Immobiliser Fuel Cut History
Comm with VALVEMATIC
Electrical Load Signal 1
Electrical Load Signal 2
Cruise Main SW
SPD (NT)
Shift SW Status (P Range)
Pattern Switch (PWR/M)
Shift SW Status (R Range)
Shift SW Status (N Range)
Shift SW Status (N,P Range) Supported
Shift SW Status (N,P Range)
Sports Shift Up SW
Sports Shift Down SW
Sports Mode Selection SW
Shift SW Status (D Range)
A/T Oil Temperature 1
ATF Thermal Degradation Estimate
NT Sensor Voltage
ECO Switch
SPD (NIN)
SPD (NOUT)
NOUT Sensor Voltage
A/T Oil Pressure
G Sensor
Lock Up
Shift Status
Solenoid (SLS)
SLU Solenoid Status
SL Solenoid Status
Solenoid(SC)
Solenoid(SLP)
G Sensor Calibration
G Sensor Learning Value
CVT Oil Press Calibration