The Controller Area Network (CAN) is a serial data communication system for real time applications. This is a vehicle multiplex communication system which has a high communication speed (500 kbps) and a high level of ability to detect malfunctions. By pairing the CANH and CANL bus wires, the communication on the CAN is performed using the voltage differential between the wires.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0129 | Lost Communication with Brake System Control Module | All of the following conditions are met for 2.22 seconds or more (1 trip detection logic): (a)
Ignition switch ON (b)
Battery voltage is 10.5 V or more (c)
No communication between ECM and skid control ECU |
·
Wire harness (CANL and CANH circuit) ·
ECM ·
Brake actuator assembly (Skid control ECU) ·
CAN communication system |
Comes on | DTC stored |
Read freeze frame data using the GTS. Freeze frame data records the engine conditions when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs
| Result | Proceed to |
|---|---|
| DTC U0129 is output | A |
| DTC U0129 and other DTCs are output | B |
If any DTCs other than U0129 are output, troubleshoot those DTCs first.
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B