Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for LHD) › 2016.10–2019.09
RM32H0E _57 Power Source / Network _059621 NETWORKING _0292522 NETWORK GATEWAY ECU(for LHD) A

NETWORKING  NETWORK GATEWAY ECU(for LHD)  REMOVAL  


PROCEDURE

Hide 55433B 1.REMOVE NO. 2 INSTRUMENT PANEL LOWER FINISH PANEL

Hide 82877 2.REMOVE ECU INTEGRATION BOX RH

a.
E357141C04
1.115,1.948 1.448,1.948 true 2.031,0.417 2.198,0.625 0.167,0.208 10 true *a 0.896,0.542 1.063,0.708 0.167,0.167 10 true *b 2.073,0.698 2.24,0.906 0.167,0.208 10 true *a 2.115,0.99 2.281,1.198 0.167,0.208 10 true *a 0.844,0.969 1.01,1.135 0.167,0.167 10 true *b 0.854,1.229 1.021,1.396 0.167,0.167 10 true *b 0.865,1.844 1.031,2.01 0.167,0.167 10 true *b
*a w/ Smart Key System
*b w/ Stop and Start System


Disconnect the connector.


b.

w/ Smart Key System:

i.

Disconnect the 3 connectors.



c.

w/ Stop and Start System:

i.

Disconnect the 3 connectors.


ii.

Using a clip remover, disengage the wire harness clamp.



d.

Using a clip remover, disengage the wire harness clamps.


e.
E357142

Remove the bolt, 2 nuts and ECU integration box RH.


Hide 89111 3.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)

a.

Disengage the claws to remove the central gateway ECU (network gateway ECU).

E357143

NOTICE:
·

If the ECU integration box RH is deformed or damaged, replace it.

·

Do not bend the claws more than necessary.