Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for RHD) › 2016.10–2019.09
RM32H0E _57 Power Source / Network _059621 NETWORKING _0292523 NETWORK GATEWAY ECU(for RHD) A

NETWORKING  NETWORK GATEWAY ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 55433B 1.REMOVE NO. 2 INSTRUMENT PANEL LOWER FINISH PANEL

Hide 82878 2.REMOVE ECU INTEGRATION BOX LH

a.
E357144

Disconnect the 5 connectors as shown in the illustration.


b.
E357146C01
2.292,0.542 2.479,0.729 0.188,0.188 10 true *a 2.26,1.031 2.448,1.219 0.188,0.188 10 true *a 2.281,1.594 2.469,1.781 0.188,0.188 10 true *a
*a w/ Stop and Start System


Disconnect the connector.


c.

w/ Stop and Start System:

i.

Disconnect the 3 connectors.



d.
E357147

Remove the bolt, nut and ECU integration box LH.


Hide 89111 3.REMOVE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)

a.

Disengage the claws to remove the central gateway ECU (network gateway ECU).

E357148

NOTICE:
·

If the ECU integration box LH is deformed or damaged, replace it.

·

Do not bend the claws more than necessary.