Home › Vehicle Interior › SEAT › LUMBAR SWITCH › 2016.10–2019.09
RM32H0E _58 Vehicle Interior _059623 SEAT _0292528 LUMBAR SWITCH A

SEAT  LUMBAR SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front lumbar power seat switch removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Front lumbar power seat switch is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE FRONT SEAT ASSEMBLY

Hide 71074S 2.DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

Hide 72495 3.REMOVE VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

Hide 72538 4.REMOVE RECLINING HINGE OUTER COVER

Hide 72526A 5.REMOVE RECLINING ADJUSTER RELEASE HANDLE

Hide 71849F 6.REMOVE SEAT ADJUSTER COVER CAP (w/ Vertical Adjuster)

Hide 71812D 7.REMOVE FRONT SEAT CUSHION SHIELD

Hide 84922A 8.REMOVE FRONT LUMBAR POWER SEAT SWITCH

a.
B453969

Remove the 2 screws.


b.

Disengage the guides to remove the front lumbar power seat switch.