Home › Vehicle Interior › SEAT › LUMBAR SWITCH
RM32H0E _58 Vehicle Interior _059623 SEAT _0292528 LUMBAR SWITCH G

SEAT  LUMBAR SWITCH  INSPECTION  


PROCEDURE

Hide 84922A 1.INSPECT FRONT LUMBAR POWER SEAT SWITCH

a.

Check the resistance.

i.
B442254C02
1.219,2.448 0.875,2.135 true 2.26,2.458 2.813,2.115 true 1.375,1 0.854,0.625 true 2.417,0.99 2.813,0.615 true 1.208,4.438 1.396,4.083 true 2.125,4.448 2,4.083 true 1.49,4.438 1.615,4.073 true 1.854,4.448 1.802,4.083 true 0.604,1.677 0.917,1.833 0.313,0.156 10 false *B 2.854,0.5 3.167,0.656 0.313,0.156 10 false *a 0.667,0.5 0.979,0.656 0.313,0.156 10 false *b 0.854,3.417 1.167,3.573 0.313,0.156 10 false *c 0.521,0.094 0.833,0.25 0.313,0.156 10 false *A 0.688,2 1,2.156 0.313,0.156 10 false *a 2.854,2.01 3.167,2.167 0.313,0.156 10 false *b 1.438,4.469 1.594,4.667 0.156,0.198 10 false E 1.125,4.469 1.281,4.667 0.156,0.198 10 false H 1.813,4.469 1.969,4.667 0.156,0.198 10 false R 2.135,4.469 2.292,4.667 0.156,0.198 10 false B
*A for LHD
*B for RHD
*a Front Lumbar Power Seat (Release)
*b Front Lumbar Power Seat (Hold)
*c Component without harness connected
(Front Lumbar Power Seat Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
5 (H) - 2 (B) Front lumbar power seat (Hold) pressed Below 1 Ω
3 (R) - 4 (E)
5 (H) - 4 (E) Off
3 (R) - 4 (E)
3 (R) - 2 (B) Front lumbar power seat (Release) pressed
5 (H) - 4 (E)


If the result is not as specified, replace the front lumbar power seat switch.