Home › Vehicle Interior › SEAT › LUMBAR SUPPORT ADJUSTER ASSEMBLY › 2016.10–2019.09
RM32H0E _58 Vehicle Interior _059623 SEAT _0292529 LUMBAR SUPPORT ADJUSTER ASSEMBLY A

SEAT  LUMBAR SUPPORT ADJUSTER ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the lumbar support adjuster assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

*2: w/ Stop and start system

CAUTION:
·
B458500

Be sure to read Precaution thoroughly before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:
·

Front lumbar power seat switch is available only on the driver side.

·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 72760D 2.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY

a.
B453970

Disconnect the connector.


b.

Disengage the clamp.


c.
B453971

Disengage the claws to separate the 2 front seatback edge protectors from the front seatback frame sub-assembly.


d.
B453972C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the guides to remove the lumbar support adjuster assembly from the front seatback frame sub-assembly as shown in the illustration.


e.
B458495

Remove the 2 front seatback edge protectors from the lumbar support adjuster assembly.