Home › Drivetrain › EC6A (MANUAL TRANSMISSION / TRANSAXLE) › MANUAL TRANSAXLE SYSTEM
RM32H0E _52 Drivetrain _059609 EC6A MANUAL TRANSMISSION / TRANSAXLE _0292533 MANUAL TRANSAXLE SYSTEM D

EC6A MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSAXLE SYSTEM  FREEZE FRAME DATA  


DESCRIPTION


A103809E88
2.354,0.135 3.229,0.302 0.875,0.167 10 DTC stored 1.271,1.031 2.052,1.208 0.781,0.177 10 0.5 seconds 0.323,1.031 1.104,1.229 0.781,0.198 10 0.5 seconds 0.354,2.792 2.688,2.948 2.333,0.156 10 Freeze frame data which can be read 2.25,1.031 3.031,1.229 0.781,0.198 10 0.5 seconds

The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

HINT:

If it is impossible to replicate the problem even though a DTC is detected, confirm the freeze frame data.


The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

·

3 data sets before the DTC was stored.

·

1 data set when the DTC was stored.

·

1 data set after the DTC was stored.


These data sets can be used to simulate the condition of the vehicle around the time of the occurrence the malfunction. The data may assist in identifying the cause of the malfunction, and judging whether it was temporary or not.


LIST OF FREEZE FRAME DATA


Powertrain > Transmission
Tester Display
BATT Voltage
Starter SW
Neutral Position SW
Stop Light SW
Cruise Main SW
Total Distance Traveled
Total Distance Traveled
Accel Position from EFI
NIM Sensor Speed
Shift SW Status (R Range)
Clutch Stroke Position
Clutch Stroke Sensor Voltage
iMT Telltale