ROAD TEST
Check for DTCs.
Click hereDrivetrain>EC6A (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>DTC CHECK / CLEAR
When DTCs are output, perform troubleshooting for each DTC.
Turn the iMT switch on and off and check that the iMT indicator light illuminates and turns off.
If the iMT indicator light does not illuminate, refer to the troubleshooting procedure for "iMT indicator light does not illuminate".
Click hereDrivetrain>EC6A (MANUAL TRANSMISSION / TRANSAXLE)>MANUAL TRANSAXLE SYSTEM>PROBLEM SYMPTOMS TABLE
Perform a road test.
When performing the confirmation driving pattern, obey all speed limits and traffic laws.
Perform this procedure with the iMT indicator light illuminated.
Make sure to securely depress the clutch pedal.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List.
| Tester Display |
|---|
| Engine Speed |
According to the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Engine Speed | Engine speed | Min.: 0 rpm
Max.: 16383 rpm |
600 to 700 rpm: Idling (shift lever in neutral, engine warmed up and A/C off) | When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed. |
Drive the vehicle in 3rd gear with the engine speed at 2000 rpm.
Fully depress the clutch pedal (and leave it depressed).
Immediately downshift to 2nd gear.
After the clutch is not engaged for 2 seconds, check the engine speed.
The engine speed exceeds 2500 rpm.