Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
87961
1.INSTALL OUTER MIRROR (for LED Type Turn Signal Light)
Connect the 2 connectors and engage the guide.
Connect the connector.
Engage the guide.
|
Install in this Direction |
Engage the claws to install the outer mirror as shown in the illustration.
Do not push the outer mirror with excessive force. Doing so may break the mirror surface.
87961
2.INSTALL OUTER MIRROR (for Bulb Type Turn Signal Light)
Connect the 2 connectors.
w/ Blind Spot Monitor:
Connect the connector.
|
Install in this Direction |
Engage the claws to install the outer mirror as shown in the illustration.
Do not push the outer mirror with excessive force. Doing so may break the mirror surface.