Home › Vehicle Interior › DOOR LOCK › BACK DOOR LOCK
RM32H0E _58 Vehicle Interior _059647 DOOR LOCK _0292601 BACK DOOR LOCK G

DOOR LOCK  BACK DOOR LOCK  INSPECTION  


PROCEDURE

Hide 69350 1.INSPECT BACK DOOR LOCK ASSEMBLY

a.

Check the operation of the door lock motor.

i.
B450711C04
1.427,3.917 0.99,4.24 true 1.708,3.917 1.708,4.365 true 1.969,3.948 2.375,4.292 true 0.615,0.25 0.927,0.406 0.313,0.156 10 false *b 0.719,1.813 1.031,1.969 0.313,0.156 10 false *c 0.688,3.354 1,3.51 0.313,0.156 10 false *a 0.771,4.146 1.083,4.302 0.313,0.156 10 false D+ 1.563,4.385 1.99,4.552 0.427,0.167 10 false ACT- 2.417,4.219 2.844,4.385 0.427,0.167 10 false ACT+
*a Component without harness connected
(Back Door Lock Assembly)
*b Close (Lock)
*c Open (Unlock)


Move the door lock to the close (lock) position.


ii.

Apply battery voltage and check the operation of the door lock motor.

OK:
Battery Connection Result
Battery positive (+) → Terminal 1 (ACT+)
Battery negative (-) → Terminal 2 (ACT-)
Back door lock motor open (unlock) operation


If the result is not as specified, replace the back door lock assembly.



b.

Check the operation of the back door courtesy switch.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (ACT-) - 3 (D+) Closed (Locked) 10 kΩ or higher
2 (ACT-) - 3 (D+) Open (Unlocked) Below 1 Ω


If the result is not as specified, replace the back door lock assembly.