1.CHECK TRANSFER OIL
Stop the vehicle on a level surface.
Using a 10 mm straight hexagon wrench and 10 x 12 mm long offset wrench, remove the transfer filler plug and gasket.
| *a | 0 to 5.0 mm (0 to 0.196 in.) |
Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the transfer filler plug hole.
If the result is not as specified, add transfer oil.
Toyota Genuine Differential gear oil LT SAE 75W-85 API GL-5 or equivalent
SAE 75W-85
When adding oil, pour it slowly.
Too much or too little oil will lead to transfer problems.
If the oil level is low, refill oil after checking for oil leaks.
| *a | 10 mm Straight Hexagon Wrench |
| *b | 12 mm Hexagon Socket Wrench |
| *c | 10 x 12 mm Long Offset Wrench |
| *d | Fulcrum Length |
Using a 10 mm straight hexagon wrench, 12 mm hexagon socket wrench and 10 x 12 mm long offset wrench, install a new gasket into the transfer filler plug and then install the transfer filler plug.
This torque value is effective when offset wrench is straight to a torque wrench.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a long offset wrench (fulcrum length of 189.75 mm (7.47 in.)) + torque wrench (fulcrum length of 255 mm (10.04 in.)): 22.4 N*m (228 kgf*cm, 17 ft.*lbf)