The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during transfer assembly removal/installation are shown below.
*1: When performing learning using the GTS.
| *a | Heavy object exceeding the capacity of the transmission jack |
Because the continuously variable transaxle assembly is extremely heavy, make sure to follow the work procedures described in the repair manual.
If work is not performed according to the procedures described in the repair manual, there is a danger that the transmission jack could drop and components could fall down.
When the engine is hot, do not touch high-temperature areas such as the engine or exhaust pipe.
Touching high-temperature areas such as the engine and exhaust pipe could result in burns.
30400
1.REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
36100
2.REMOVE TRANSFER ASSEMBLY
Remove the 6 nuts and transfer assembly from the transaxle.
36100A
3.REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT
It is not necessary to remove the transfer and transaxle setting stud bolts unless they are being replaced.
Remove the 2 transfer and transaxle setting stud bolts.